Operation Manual

Page33

LOCK FACILITY

X3 has a built in Lock facility designed to restrict access.

Pin Protection - Hard Drive Format / File Manager.

Folder Protection - User Folders

You can enable or disable these options in the Setup menu

PIN PROTECTION

Enable Pin Protection to protect access to the Hard Drive Format area and the File

Manager functionality. Once the Pin Protection is enabled you will be prompted to

enter your personal 4 digit pin code when trying to gain access to these screens.

CHANGE PIN CODE - The default 4 digit Pin Code is 0000

To change the Pin Code go to Setup -- Misc -- Password -- You will be prompted to enter the existing pin

code. For first time use you must enter the default factory pin ‘0000' and then the Pin Code change screen will

open. Enter the default pin again and enter your new personal 4 digit code twice by pressing the numbers on

your remote. Once you have entered the code press the “ENTER” button on the remote and the new code will

be saved.

FOLDER PROTECTION

Folder protection will allow you to protect folders on the internal Hard Drive, USB Drives,

SD Card or Network Shares (write enabled shares). To protect a folder focus on the folder

and press the ‘EDIT’ button on the remote. Select the ‘Lock’ icon and the folder will be

locked. To unlock a folder, focus on the folder and press the ‘EDIT’ button on the remote. Select the ‘Unlock’

icon and you will be prompted to enter your Pin Code. After the correct code is entered the folder will be

Unlocked.

RESET PIN CODE

To reset the Pin Code re-install the latest firmware and the Pin Code will default back to ‘0000'

Lock Folder

Unlock Folder

SAFELY REMOVE USB DRIVES- Beta Functionality

The Safely Remove Hard Drive is designed to dismount the Internal Hard Drive or

USB Drives. To dismount a drive - navigate to the ‘Devices’ page and press the ‘F2'

Button on the remote. A new page will open with a drop list of available drives that

can be dismounted. Select the drive you want to

dismount and press ‘Enter’ and X3 will then

dismount the drive. You should remove the Drive

without delay.

Note: Drives that are being read from or written to in

Samba NAS will be dismounted. This can cause data

corruption so we suggest that you do not dismount drives

that are being written to via the Samba NAS.