User's Manual

55 Slip rubber seal onto piston
until it snaps into place. The
side with the larger diameter
faces the handle. A yellow
ridge should be visible above
the seal if rubber seal
sits prop-
erly. After assembly,
hold the
rubber seal firmly and twist the
piston to ensure the seal is seated properly.
66 Slide vacuum regulator ring
onto cylinder, if not already
done. Push handle end of piston
into cylinder.
77 Screw the cylinder into the back
of the connector.
88 Center breastshield(s) over
nipple(s) and start pumping.
This kit includes everything you need to manual breast-
pump. Follow the instructions and assemble as shown below
for Lactina Pumping System.
Manual Breastpumping
11 Snap white membranes onto
yellow valves until membranes
lie completely flat. Be sure to
separate membranes and valves
when cleaning.
22 Push valves into place on
breastshield (if 1-piece breast-
shield) or on connectors (if
2-piece breastshield).
33 If using the 1-piece breastshield,
insert the small end of the
PersonalFit breastshield into the
small end of the Connector.
(Prior to cleaning, separate
these two pieces.)
44 Screw containers onto breast-
shield or use disposable
Collection Storage and Freezing
(CSF) Bags, article #87010 or
#87013 (sold separately).
1918
Vacuum Regulator Ring