Owner's Manual

183
Problem Possible Cause and Solution
The speakers produce a “pop” sound
whenever the power is turned ON or OFF.
This is normal and is no cause for alarm.
There is no sound when the keyboard is
played.
The master volume may be set too low. Please adjust it to the appropriate
level.
The speaker mode may be set as “Always OFF”.
The volume of individual parts may be set too low. Please adjust them to
an appropriate level.
The [FADE IN/OUT] switch may be turned on. Please turn it o.
All the keyboard part switches may be turned o. Please turn on at least
one part.
The playing channel may be muted. Please enter the MIXER interface
menu to turn on it.
There is noise from the instrument. Using a mobile phone in close proximity to the instrument may produce in-
terference. To prevent this, please use it further away from the instrument.
The sound is distorted or noisy. Some settings related to volume may not be adjusted properly. Please
check and adjust them.
Some eects parameters may be not set to reasonable values. Please
check and make adjustments.
Some eects will produce noise when adjusted. This is normal and is no
cause for alarm.
No sound after selecting a sound in the
selection menu.
Check if the sound of the corresponding part is selected and the part
switch is turned on.
Dierent keys have similar pitch or sound
when some Sounds are selected.
This is normal and is no cause for alarm.
No sound after pressing [START/STOP] to
start Style playback.
A piano style may be selected. Pressing [START/STOP] will play a percus-
sion channel rst, but piano style doesn’t have a percussion channel.
No response after pressing “Cancel” chord
in the chord area.
Check whether the current chord playing mode has been set to “multi-n-
gered” or “Bass-invert”.
Cancel and Cancel 2 can not be triggered in S.Fingered mode.
The Vocal Harmony sounds out of tone or
distorted.
The Vocal Harmony eect may produce an unstable pitch when the vocal
pitch remains unstable. When the song is playing, it may be because the
microphone is too close to the speaker or other sounds nearby are being
input into the microphone. Please try to adjust.
The sustain pedal is connected but there is
no sustain eect when the pedal is used.
Try to turn the instrument o and turn on it again wihile stepping the sus-
tain pedal. It is recommended to use the ocial standard pedal. If you are
using a sustain pedal with a polarity switch, please adjust the pedal.
MIDI le or Style le cannot be opened. This is usually due to large les. In this case, the system will remind you.
Part of the text is displayed in squares. This is because the le name contains characters that the system does not
recognize.
The boot time seems to be getting longer. When there is too much user data in the instrument, the boot speed may
be slightly longer.
Troubleshooting