User's Guide

Training
The training video is optional; however, it is highly recommended to ensure proper use
of the MyNotifi™ device, as well as, to fully understand how to read the user reports.
Maintenance and disposal
Cleaning instructions
MyNotifi™ can be wiped clean using germicidal wipes (Clorox Germicidal Wipes con-
taining 0.55% bleach), or household bleach diluted in water using a slightly dampened
rag. The device should not be laundered, should not be immersed in liquid of any kind
and should not be cleaned with any chemicals representing extremes of pH, such as
acids or bases. A moistened rag as described above is sufficient for cleaning purposes
and should be followed by the use of a dry towel.
Reuse and Disposal
MyNotifi™ is designed to be used by only one person.
Storage™ requirements
For storage purposes, extremes in temperature should be avoided. Do not store the
device near heat generating equipment.
Battery life
The battery is the only component with an “expiration” period. The battery has a life-
time charge loss depending on temperature and charging discipline. It is recommend-
ed that batteries be fully charged, at minimum, once every month when not in use to
not experience possible capacity loss. For example, if a battery is left on a shelf for 2
years at 25° C, it will lose roughly 40% of its storage capacity. As such, there is no real
“marked” expiration date for the battery. For additional information see energizer link.
Caution: Risk of explosion if battery is replaced by an incorrect type. Dispose of used
batteries according to the instructions
Recharging the mobile device
Recharge the mobile device as needed using the charger provided.
A routine complete charge cycle is approximately 2.5 hours. Note: During charging,
the “idle timer” feature is inactivated.
Recharging the MyNotifi™ device
It is recommended that the MyNotifi™ device be charged once the charge indicator
falls between 10% and 20%. In order to complete charging, the user places the wrist-
band on the charging mat, face down. The charging mat LED will light and the charger
will tone when device makes full charging contact. The charging mat is plugged in un-
til charge is complete. The charging system being utilized is a Qi compatible inductive
charging system. This consists of a receiver coil embedded in the insole (Figure 4) as
well as a dual coil transmitter charging base. The Charging circuit will automatically
stop charging when the battery is fully charged and will trickle charge afterwards to
maintain optimum charge.
Warning: Charge only with the charger provided with your Mynotifi™ device and in
accordance with these instructions
Servicing instructions
As with all electronic devices, there may be instances in which an upgrade on ex-
isting software might be necessary, including either or both uploads or downloads.
This process will occur automatically through secured user interface. In the event that
such upgrading activities are necessary, MyNotifi™ will provide users an email notifi-
cation of the event. Contact MedHab at 800-541-1420 if you have difficulty uploading
upgrades. The MyNotifi™ device contains no repairable parts. If your MyNotifi™ device
does not function properly, contact MedHab™ at 800-541-1420.
Warnings
• Charge only with the charger provided with your MyNotifi™ device and in ac-
cordance with these instructions. Do not open the battery, dispose of in fire,
or short circuit the battery—it may ignite, explode, leak, or become hot and
therefore, cause personal injury
• Do not overcharge the battery. Overcharging a lithium polymer battery can
cause an explosion or fire.
• Do not puncture the battery. Fire can occur if the battery cell is punctured.
•
Risk of EMI interference of the wireless communication with other medical
devices.
Precautions
• For proper data transmittal, the mobile device must not be further than 30 me-
ters (98 feet) away from the MyNotifi™ device.
• Use only the charger provided with your MyNotifi™ device.
• MyNotifi™ is waterproof™, but has not been tested past 10 feet in depth.
• Cleaning chemicals could damage the MyNotifi™ device. Follow the instruc-
tions in the Cleaning section of this document.
Adverse reactions
• Users may experience skin irritation if allergic to urethane, the wristband ma-
terial.
• If allergic to urethane, MyNotifi™ is not recommended for use.
The following symbols may appear on your MyNotifi™ device:
Symbol Meaning
Direct Current
Type BF
Caution
Consult Accompanying Documents
Refer To Instruction Manual/Booklet
Specifications
Allowable user weight range:
Non Specified
Classifications
Type BF Applied Parts
Environmental conditions
Transport & Storage Temperature: 15°C - 25°C (59°F - 77°F)
Operating temperature range: 0°C - 50°C (32°F - 122°F)
Wireless communication
Blue Tooth Low Energy
Battery
3.7V 110mAh Lithium Polymer Rechargeable Battery
PCM and 10k NTC with Standard Molex Connector
Dimensions: 3.8 x 24 x 36mm
Cell carries UL1642, IEC 62133, UN/DOT38.3
Shipping weight
-1lbs
LC -004 Rev 2 [Date of issuance document control 8-01-2018]
For product information, questions pertaining to sales and service, please contact
your local sales representative or MedHab customer service.
The user’s process for receiving and using the MyNotifi™ device
• MedHab Ships The Device To The User
• User unpacks contents of box
• User places device on supplied charger (see Figure 2)
User Signs Into Web Based Account
• User registers online via computer or smart device
• User downloads app from app store
User Creates and Follows Exercise Program On Mobile App
The mobile device app systematically moves the user through each exercise through
audible and written language. Once exercises are complete, users simply press “stop
recording”. Data is automatically uploaded to the secured cloud based website for au-
tomatic report generation. Dashboards of all exercises can also be seen on the app
dashboards immediately. The mobile app contains instructions available at all times for
users utilizing the device, including instructional videos for each exercise.
Figure 2
Charging the device while in the
wristband: bands must be connected
and the device must be face down.
Charging the device while in the belt-
clip: clip must be face down with belt
attachment facing up.