User`s manual

USER`S MANUAL ME-TUN
File: ME-TUN Manual E.DOC MEDIA ENGINEERING page 12/29
B.1. BASIC OPERATIONS
B.1.1. STARTUP SEQUENCE
After proper installation of the ME-TUN (refer to A.2. INSTALLATION PROCEDURE on page
7), flip the “OFF-POWER-ON” switch on the rear side to the “ON” rsp. upper position in order
to start up the device. Upon power on, ME-TUN enters the initialization sequence and
displays the firmware version information on its LCD display (screen 1).
screen 1
Simultaneously all keys on the keypad will light up briefly
1
. A few seconds later, ME-TUN will
enter the INITIAL state (refer to section B.1.3: INITIAL STATE on page 13)
B.1.2. LIT UP KEYS
ME-TUN has quite a large number of keys, but is nevertheless operated very simply. Only
the lit up keys react on user input. No matter in what position of the input sequence the
operator is, the ME-TUN will light up only those keys, which are meaningful for the next
keystroke.
1 2 3 LOAD
DISP
4
↑PGM
5
↑25kc
6
LOCK
0
SCAN
7
↓PGM
8
↓25kc
9
ANTA/B
SAVE
MENU
keypad 1: INITIAL STATE
“keypad 1” shows an example: The keyboard is ready for user input on keys 1,8,9,LOAD or
SAVE. All other keys are disabled and have no function. Thus, ME-TUN will guide you
through the required steps to set up the tuner as desired.
1
This serves as a test for the LED illuminated push-buttons.
B. OPERATING INSTRUCTIONS
ME-TUN R1.2
Media En
g
ineerin
g