User`s manual

USER`S MANUAL ME-TUN
File: ME-TUN Manual E.DOC MEDIA ENGINEERING page 24/29
By pressing the LOAD button ME-TUN will effectively start the scanning function. During
scanning, there will show up a backlight sequence of the LED illuminated push-buttons
(simulating a tuning wheel rotating counter clock wise) and the tuning frequency will be
decreased in 100kHz steps starting from 108.000MHz. Also shown is the actual preset
number that ME-TUN will use to store a channel.
screen 9
When ME-TUN finds a strong enough channel (the threshold is set to 50dBµV) the center
key “5” on the keypad will light up briefly and the preset number on the LCD display will be
decremented by 1. After reaching the bottom end of the FM band (87.500MHz), ME-TUN will
show the number of stations that have been found and saved during the scan.
screen 10
By hitting the LOAD button ME-TUN will load the last station it has found (in case of “05
programs found” this is preset number 35) and returns to its INITIAL state (refer to section
B.1.3: INITIAL STATE on page 13).
In order to check which programs ME-TUN has found during scanning, the “stepping through
presets” function (as described in chapter B.2.2. STEPPING THROUGH PRESETS on page
20) can be used.
107.900MHz stereo ҰA
RFL
|
■■■■

|
P39
05 programs found!