User`s manual

USER`S MANUAL FM-SPY-T
File: FM-SPY-T Manual E.DOC MEDIA ENGINEERING page 29/41
C.2. SOFTWARE INSTALLATION
The software installation under MICROSOFT WINDOWS is quite easy to achieve. The
software runs on all MICROSOFT WINDOWS operating systems incorporating the
handling of USB 1.1 interfaces such as WIN98, WIN2000, WINXP but not on WINNT.
IMPORTANT NOTE
: FIRST install the software
SECOND
make the USB connection
The installation process is started by running the installation program
“setup.exe”
directly from the CD-ROM with the original FM-SPY software package or from a previously
created directory on the harddrive containing a copy of the CD-ROM. During the installation
process all necessary drivers plus the FM-SPY application will be installed on the PC.
SECOND (and only now): establish the USB connection from the FM-SPY to the PC
while the PC is running
. The operating system is then
recognizing the new device and is searching and installing
the proper drivers automatically.
!
In case the the FM-SPY-T is connected to the PC before the software is installed
it might be necessary to install the drivers manually.
Test procedure
: After the software installation but while the FM-SPY
application is NOT running switch off the FM-SPY-T
hardware device with its power switch on the rear side.
After some seconds switch it back on again and watch how
a) the frontpanel LED named USB is illuminated
b) the two alarm LEDs AL1 and AL2 will go dark after
approximately 2 seconds
If both testpoints a) and b) are successfully outperformed the PC has detected the FM-SPY-
T as a new USB device, loaded the propre driver(s) and downloaded the propre firmware into
the USB processor located in the FM-SPY-T hardware device. The computer is ready to
start the FM-SPY application.