User`s manual

USER`S MANUAL FM-SPY-T
File: FM-SPY-T Manual E.DOC MEDIA ENGINEERING page 8/41
A.2. INSTALLATION PROCEDURE
Place the FM-SPY-T FM sound broadcasting analyser in a horizontal position, and do not
place anything heavy on it. Never bring a magnet or magnetized objects near the device,
because such will adversely affect the performance of the FM-SPY-T.
Should it be necessary to change the sampling rate of the digital audio output to another
value than the factory set 48kHz please refer to chapter A3.
In case the FM-SPY-T has to be installed in a 19” rack the appropriate 19” brackets have to
be mounted first in order to convert the table top device into a rack mountable device:
a) loosen the two black M4 screws on the left and right side of the FM-SPY-T with the
help of an appropriate 2.5mm PHILIPS screw driver
b) put the two screws beside for they will be used again at the end
c) unpack the two blue 19” brackets that are delivered as an add-on to every FM-SPY-T
d) with a little movement from back to forward the brackets can be hooked into place
while the U-shaped end of the bracket is grabbing around the end of the side wall.
e) carefully replace the M4 screws from the left hand side rsp. from the right hand side
and tighten them slightly (“two finger” torque)
It’s a good rule of practice to mount at least a 19”/1RU blank panel on top and below each
19” rack mountable device. The same is true for the FM-SPY-T and - whenever possible - a
blank panel above and below each FM-SPY-T should be mounted.
FM-SPY-T with demounted 19” brackets (front view)