User`s manual

BLUETOOTH
CLIP-ON EARSET
User’s manual
MT3535
EN
Overview
Using the device
Charging – internal ringer will sound three
short beeps continuously when battery is low.
TO start charging plug one end of USB cable to
the charger socket of MT3535, other end plug to
the USB power supply. Red LED indicator is on
when charging in progress, red LED is o when
rechargeable battery is full.
Power ON – to power ON press and hold an-
swer/end button for 2 seconds until LED indi-
cator starts to  ash red blue. Internal ringer will
sound three short beeps.
Power OFF – to power OFF press and hold an-
swer/end button for about 5 seconds until LED
indicator is o . Internal ringer will sound three
short beeps.
Pairing the device – turn on device in standby
mode. Seek for new Bluetooth devices in your
mobile phone, when prompted enter passcode
0000. You only need to pair device once. If pair-
ing is successful blue LED indicator start to blink.
Answer call – when you receive an incoming
call, you will hear ringing in the headset, press
answer/end button once.
End call - during conversation press answer/end
button once.
Reject call – when you receive an incoming call
press and hold answer/end button for at least 1
seconds to reject a call.
Redial last number – when in standby mode,
press shortly answer/end button twice.
Voice dialing – your mobile phone must sup-
port voice dialing. When in standby mode press
answer/end button until you hear a prompt –
then say name from phonebook. Best result are
when voice dialing records are made through
MT3535 headset. Follow mobile phone user’s
manual for more details.
Volume Up – during music playback press once
to increase volume, when the highest level is
reached you will hear two beeps.
Volume Down – during music playback press
once to decrease volume, when the lowest level
is reached you will hear two beeps.
1. Earphone
2. Charger socket
3. Indicator LED
4. Answer/End button
5. Microphone
6. Volume +
7. Volume -
Note!
Please fully charge headset before  rst use.