Hardware manual

Chapter 5 - Setting up the nTouch 180 unit
24 Version 1.7.2.0 March 27, 2015
Note: If you let the counter reach zero, Kiosk will start automatically. If you have a
keyboard connected, you can press ALT+F4 to display the Starting Kiosk screen. If
you do not have a keyboard connected, you will need to reboot the unit to access the set
up screen.
If no username has been specified, the main set up screen is displayed.
Tip: The Exit button is only available on the main set up screen if a project name has been
specified.
3. Press Network Setup.
4. Clear the DHCP check box.
5. Touch the IP Addr box, then type an IP address using the on-screen keyboard.
Note: The IP address must be unique on the network to avoid conflicts.
6. If your subnet is connected to a router, specify the router's IP address in the Gateway box.
If you have no router, leave the Gateway box blank.
7. Type the network mask in the Subnet box.
8. If you intend to use a domain name to identify the nTouch 180 on the network, e.g.
nTouch180-mainroom.mediamatrix.corpname.net, type the IP address of a DNS in the
DNS box.
9. Press OK.