Hardware manual

Chapter 5 - Setting up the nTouch 180 unit
32 Version 1.7.2.0 March 27, 2015
Specifying the network settings
Network ports
Before you specify network settings, make sure you know which physical interfaces at the side
of the nTouch 180 unit Local Area Connection and Local Area Connection 2 on the
Network screen correspond to.
Setting the IP address
Using DHCP to assign an IP address automatically
1. Confirm that the network to which you are connecting the unit has a DHCP server.
Notes:
 If DHCP mode is selected, but there is no DHCP server on the network, the unit will
be unable to communicate with other devices.
 In this example, the DHCP server is provided by the router. Ensure that your network
is using a router. A plain switch will not provide the required DHCP server for the
example.
2. Navigate to the Network screen.
3. Under Local Area Connection x (where x is the interface number), in the IP
Configuration Method list, click DHCP.
4. Click Set to confirm the action.
You will be asked to log on.
5. Specify your username and password. The default username is superuser; it has no
password.