Hardware manual
Table Of Contents
- Cover Page
- Contents
- About this guide
- Safety Instructions and safety warnings
- Before you start
- Introduction to NION
- Setting up the NION
- Introduction
- Configuration
- Updating the firmware
- Using the front panel
- Using the web interface
- Using XDAB clusters with VLANs and CobraNet
- Introduction
- Important concepts
- Use cases
- Scenario 1 - Basic network
- Scenario 2 - Network using VLAN
- Scenario 3 - Network with VLAN and analog interconnects
- Scenario 4 - Network with VLAN and digital interconnects
- Scenario 5 - Network with an XDAB cluster
- Scenario 6 - Network with VLAN and XDAB
- Scenario 7 - Network with VLAN and XDAB
- Scenario 8 - Network with VLAN and two XDAB clusters
- Scenario 9 - Network with VLAN and three XDAB clusters
- Setting conductor and XDAB priority in NWare
- Further examples
- Troubleshooting
- Connector ports
- Technical specifications
- Reference Information
- Warranty statement
Chapter 5 - Setting up the NION
34 Version 1.6.2a.0 May 17, 2011
So
me text t o force a page b reak in Word but remain inv isible
Disabling security
1. From the main menu, select CONFIG to display the first configuration page, LAN
CONFIG, then select NEXT repeatedly until the FRONTPANEL COMBO page is
displayed.
2. Using the wheel and the wheel push button, move the cursor to each OLD COMBO field
and select a number to specify the current combination.
3. Move the cursor to each NEW COMBO field and select
0 0 0 0 as the new combination.
4. Move the selection to APPLY and press the wheel push button.
5. Select HOME to return to the main page.
Changing the security combination
1. From the main menu, select CONFIG to display the first configuration page, LAN
CONFIG, then select NEXT repeatedly until the FRONTPANEL COMBO page is
displayed.
2. Using the wheel and the wheel push button, move the cursor to each OLD COMBO field
and select a number to specify the current combination.
3. Move the cursor to each NEW COMBO field and select a number to specify the new
combination.
4. Move the selection to APPLY and press the wheel push button.