Hardware manual
Table Of Contents
- Cover Page
- Contents
- About this guide
- Safety Instructions and safety warnings
- Before you start
- Introduction to NION
- Setting up the NION
- Introduction
- Configuration
- Updating the firmware
- Using the front panel
- Using the web interface
- Using XDAB clusters with VLANs and CobraNet
- Introduction
- Important concepts
- Use cases
- Scenario 1 - Basic network
- Scenario 2 - Network using VLAN
- Scenario 3 - Network with VLAN and analog interconnects
- Scenario 4 - Network with VLAN and digital interconnects
- Scenario 5 - Network with an XDAB cluster
- Scenario 6 - Network with VLAN and XDAB
- Scenario 7 - Network with VLAN and XDAB
- Scenario 8 - Network with VLAN and two XDAB clusters
- Scenario 9 - Network with VLAN and three XDAB clusters
- Setting conductor and XDAB priority in NWare
- Further examples
- Troubleshooting
- Connector ports
- Technical specifications
- Reference Information
- Warranty statement
NION Hardware Manual
May 17, 2011 Version 1.6.2a.0 41
8. Type binary to switch to binary copy mode.
9. Type
mput <filename> and press Enter.
The parameter <filename> is either a single file or a wildcard referencing multiple files.
When you have finished copying files, type
quit to close the ftp session.
Managing users
Introduction
Users are created via the web interface, and assigned privileges to allow them to perform
certain operations, as listed below.
Privilege What it controls
Deploy Determines whether the user can deploy a role to this node.
Update Firmware Determines whether the user can update the firmware on this
node.
Debug Menu Access Determines whether the user can access the debug menu of
this node using the Pandebug application.
User Administration Determines whether the user can create, edit and remove user
accounts on this node.
NioNode Administration
Access
Determines whether the user can change settings such as
network configuration and time and date.
Log Access Determines whether the user can view or clear the log.
Tip: For more information on viewing the log within NWare,
see Remote Log in the NWare User Guide.
There are two default users: superuser and defaultuser, which cannot be deleted. You can
add your own users as necessary.
superuser Has all privileges enabled. None of its settings can be
changed, apart from the password, which is blank by default.
defaultuser Has all privileges enabled, apart from User Administration
and NioNode Administration Access.
In NWare, when you perform an action that involves the node, such as deploying a role or
updating firmware, NWare logs on to the node using a particular username. The node matches
this username with the username of the same name stored on the unit. The privileges of the
username on the node determine whether the action may be carried out.
Tip: Users often log on to nodes with the username defaultuser. If the settings for this
username on the node show the Deploy privilege set to Disallow, it will not be possible to
deploy a role to the node even when they are logged on.