Hardware manual
Table Of Contents
- Cover Page
- Contents
- About this guide
- Safety Instructions and safety warnings
- Before you start
- Introduction to NION
- Setting up the NION
- Introduction
- Configuration
- Updating the firmware
- Using the front panel
- Using the web interface
- Using XDAB clusters with VLANs and CobraNet
- Introduction
- Important concepts
- Use cases
- Scenario 1 - Basic network
- Scenario 2 - Network using VLAN
- Scenario 3 - Network with VLAN and analog interconnects
- Scenario 4 - Network with VLAN and digital interconnects
- Scenario 5 - Network with an XDAB cluster
- Scenario 6 - Network with VLAN and XDAB
- Scenario 7 - Network with VLAN and XDAB
- Scenario 8 - Network with VLAN and two XDAB clusters
- Scenario 9 - Network with VLAN and three XDAB clusters
- Setting conductor and XDAB priority in NWare
- Further examples
- Troubleshooting
- Connector ports
- Technical specifications
- Reference Information
- Warranty statement
Chapter 1 - About this guide
2 Version 1.6.2a.0 May 17, 2011
So
me text t o force a page b reak in Word but remain inv isible
Scope
This guide describes how to physically install a NION and configure it with basic settings.
Once you have completed the installation, we recommend that you refer to the NWare User
Guide to see how to design an audio solution and download settings to the NION.
Documentation conventions
The following are used in the documentation to highlight particular sections of information.
Tip: Suggests alternative ways of completing a task and shortcuts that might not otherwise be
obvious.
Note: Indicates important information that should not be ignored.
Caution: Indicates that unless you are careful, your actions could result in equipment damage
or loss of data.
Warning: Indicates that unless you are careful, your actions could result in injuries to
personnel.