Hardware manual
Table Of Contents
- Cover Page
- Contents
- About this guide
- Safety Instructions and safety warnings
- Before you start
- Introduction to NION
- Setting up the NION
- Introduction
- Configuration
- Updating the firmware
- Using the front panel
- Using the web interface
- Using XDAB clusters with VLANs and CobraNet
- Introduction
- Important concepts
- Use cases
- Scenario 1 - Basic network
- Scenario 2 - Network using VLAN
- Scenario 3 - Network with VLAN and analog interconnects
- Scenario 4 - Network with VLAN and digital interconnects
- Scenario 5 - Network with an XDAB cluster
- Scenario 6 - Network with VLAN and XDAB
- Scenario 7 - Network with VLAN and XDAB
- Scenario 8 - Network with VLAN and two XDAB clusters
- Scenario 9 - Network with VLAN and three XDAB clusters
- Setting conductor and XDAB priority in NWare
- Further examples
- Troubleshooting
- Connector ports
- Technical specifications
- Reference Information
- Warranty statement
Chapter 6 - Using XDAB clusters with VLANs and CobraNet
58 Version 1.6.2a.0 May 17, 2011
So
me text t o force a page b reak in Word but remain inv isible
Adjusting the CobraNet Conductor and XDAB clock master priorities
1. Right click on the NION on the NWare page, and then click Device Properties.
The NioNode Properties dialog box is displayed.
2. Click Advanced.
The Advanced properties dialog box is displayed.
3. In the CobraNet Conductor Priority list, click the priority range for the NION.
4. In the XDAB Clock Master Priority list, click the priority range for the NION.
Tip: If you want a NION to be an XDAB master or a CobraNet Conductor, set the
appropriate range to be higher than any other device in the cluster.