User Guide

No. of HDDs

RAID MODE

RAID 0 (Spanning)

Single

RAID 0 (Striping)

RAID 1 (Mirroring)

RAID 3

RAID 5

RAID 10

1xHDD 2xHDD

3xHDD

4xHDD

Figure-1

: Supported : N/A

D. Take the transport paper

board out of the device.

E. Slide 4 HDDs into the chassis and

make sure they are securely

installed in order from up

to down.

F. Adjust the metal frame that was removed

in Step C. Please make sure the

bottom of the frame stays

inside the track before

closing the cover.

G. Connect the power supply to the device, plug in either USB or eSATA

cable in the rear panel and power on the device.

5 65 6

SETUP

RAID mode setup

1. Make sure the PC is ON and ready to go, then power on the device.

2. There are several mode options for HFR2-SU3S2,

RAID 0 (Spanning), RAID 0 (Stripping), RAID 1, RAID 3, RAID 5 and RAID 10

The enclosure is not default to any of the above.

So If you just put hard drives in without setting a mode to use,

the enclosure will just turn off after a few seconds of turning it ON.

The RAID confirmation button is hidden in the back,

so please find it first before you start.

The setup procedures are as follows,

Make sure the enclosure is connected to a computer that is ON.

Power on the enclosure and press and hold MODE button

on the front until mode option LED flashes.

Press it again to select the RAID mode you want,

then press the Confirmation button on the back panel

until the device shuts down.

Power on the device again and the RAID mode set-up is completed.

Now you just need to partition and format the drives.