User Manual

SETUP

RAID Mode Setup

There are several mode options for HFR7-SU31CD, Single, JBOD (Spanning),

RAID 0 (Striping) and RAID 1. The enclosure is not default to any of the above.

So If you just put hard drives in without setting a mode to use, the enclosure

will just turn off after a few seconds of turning it ON.

‧Changing RAID mode may cause data lost,

backup your data before making changes.

‧Do not use hard drives containing data

to create a RAID array.

When using RAID function, HDDs with the same brand, model and capacity

is strongly recommended.

2. The Device is built in 2 sets of RAID, and each RAID is constructed by 2 HDDs.

There are two sets of Raid mode need to be setup properly before you using

this device, finds " SET 1" and "SET 2" in the front panel on this device.

Front panel

SET 1 SET 2

3. The setup procedures are as follows:

Press and hold the "SET 1" button until the RAID option

light starts to flash then let go of "SET 1" button.

Front panel

Press and hold

Flash

1. First install the HDD from up to down in the enclosure.

Make sure the PC is on and ready to go, Power on the device.

Front panel

Default setting is at

Single & Automatic mode