User Manual

4. Take the transport paper board out of the device.

5. Slide 4 HDDs into the chassis and make sure they are securely installed

in order from top to bottom.

6. Reinstall the metal frame that was removed in Step 3.

Please make sure the bottom of the frame stays inside the track

before closing the cover.

7. Connect the power supply to the device, plug in either USB-C cable

in the rear panel and power on the device. Make sure computer is ON.

Make sure the HDD is securely

installed first at all times.

Otherwise the PC may not recognize

the device.

3.5 HDD

SETUP

RAID Mode Setup

1. First install the HDD from up to down in the enclosure. Make sure the PC is on

and ready to go, Power on the device.

2. The Device is built in 2 sets of RAID, and each RAID is constructed by 2 HDDs.

There are two sets of Raid mode need to be setup properly before you using

this device, finds " SET 1" and "SET 2" in the front panel on this device.

3. The setup procedures are as follows:

There are several mode options for HFR7-SU31CH, Single, JBOD (Spanning),

RAID 0 (Striping) and RAID 1. The enclosure is not default to any of the above.

So If you just put hard drives in without setting a mode to use, the enclosure

will just turn off after a few seconds of turning it ON.

‧Changing RAID mode may cause data lost,

backup your data before making changes.

‧Do not use hard drives containing data

to create a RAID array.

Press and hold the "SET 1" button until the RAID option

light starts to flash then let go of "SET 1" button.

Front panel

SET 1 SET 2

Press and hold

Flash

When using RAID function, HDDs with the same brand,

model and capacity is strongly recommended.