Users Manual Part 3

Replacement procedure (short M.2 solid-state drive)
1. Disable the built-in battery. See “Disable Fast Startup and the built-in battery” on page 37.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close the computer display and turn over the computer.
4. Remove the base cover assembly. See “Base cover assembly” on page 38.
5. Remove the M.2 solid-state drive:
a. Remove the screw that secures the M.2 solid-state drive
1 and then the drive pivots upward.
b. Carefully remove the drive out of the slot
2 .
Chapter 6. CRU replacement 43