User Guide

MT7921K

Install User Guideline: Part-I

Confidential B

MediaTek Confidential

Page 19 of 19

This document contains information that is proprietary to MediaTek Inc.

Unauthorized reproduction or disclosure of this information in whole or in part is strictly prohibited.

2.10 Additional testing, Part 15 Subpart B disclaimer

This transmitter module is tested as a subsystem and its certification does not cover the FCC

Part 15 Subpart B (unintentional radiator) rule requirement applicable to the final host. The final

host will still need to be reassessed for compliance to this portion of rule requirements if

applicable.

As long as all conditions above are met, further transmitter test will not be required. However,

the OEM integrator is still responsible for testing their end-product for any additional compliance

requirements required with this module installed.

IMPORTANT NOTE: In the event that these conditions can not be met (for example certain

laptop configurations or co-location with another transmitter), then the FCC authorization is no

longer considered valid and the FCC ID can not be used on the final product. In these

circumstances, the OEM integrator will be responsible for re-evaluating the end product

(including the transmitter) and obtaining a separate FCC authorization.

Manual Information To the End User

The OEM integrator has to be aware not to provide information to the end user regarding how to

install or remove this RF module in the user’s manual of the end product which integrates this

module.

The end user manual shall include all required regulatory information/warning as show in this

manual.

OEM/Host manufacturer responsibilities

OEM/Host manufacturers are ultimately responsible for the compliance of the Host and Module.

The final product must be reassessed against all the essential requirements of the FCC rule

such as FCC Part 15 Subpart B before it can be placed on the US market. This includes

reassessing the transmitter module for compliance with the Radio and EMF essential

requirements of the FCC rules. This module must not be incorporated into any other device or

system without retesting for compliance as multi-radio and combined equipment.