User Guide
Table Of Contents
- 1 General Information & Integration Instructions
- 1.2 Antenna information
- 1.3 Host Integration instructions
- 1.4 Host product testing guidance
- Federal Communication Commission Interference Statement
- Radiation Exposure Statement:
- This module is intended for OEM integrators only. Per FCC KDB 996369 D03 OEM Manual v01 guidance, the following conditions must be strictly followed when using this certified module:
- KDB 996369 D03 OEM Manual v01 rule sections:
- 2.7 Antennas
- The following antennas have been certified for use with this module; antennas of the same type with equal or lower gain may also be used with this module .
- This device is intended only for OEM integrators under the following conditions: (For module device use)
- Cet appareil est conçu uniquement pour les intégrateurs OEM dans les conditions suivantes: (Pour utilisation de dispositif module)
- IMPORTANT NOTE:
- IMPORTANTENOTE
- End Product Labeling
- Plaque signalétique du produit final
- Manual Information To the End User
- Manuel d'information à l'utilisateur final
- 取得審驗證明之低功率射頻器材，非經核准，公司、商號或使
- 用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。
- 低功率射頻器材之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時， 應立即停用，並改善至無干擾時方得繼續使用。前述合法通信，
- 指依電信管理法規定作業之無線電通信。
- 低功率射頻器材須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。
- 本模組於取得認證後將依規定於模組本體標示審驗合格標籤。
- 應避免影響附近雷達系統之操作。
- 高增益指向性天線只得應用於固定式點對點系統。
MT7922A22M
© 2021 MediaTek Inc.
This document contains information that is proprietary to MediaTek Inc.
Unauthorized reproduction or disclosure of this information in whole or in part is strictly prohibited.
Page 5 of 14
1.3 Host Integration instructions
The product is designed to be used with “NGFF (Next Generation Form Factor) M.2 2230” PCIE Bus, please
install module into a M.2 2230 PCIE slot.
1.4 Host product testing guidance
HOST must follow the specific restrictions listed in “3.5 Regulatory notes” section below and section 3 of
KDB996369 D04 V02 Module Integration Guide v01, to verify that the host product meets all the applicable
rules.