User guide

- 15 -
Connecting to a USB port
Plug in the USB-to-serial port adapter into the computer and follow the
instructions that come with the cable within the instruction leaflet and
installation ‘Wizard’. Once installed, attach the other end to the MHM 100.
Follow the instructions in the previous section.
Installing the software
To install the software, whether it is on a personal computer or one that is part
of a network, you will need to log in as an administrator before you can
proceed. This means that if you are using a company computer, you will need
to contact your IT dept.
1. Put the Medick Resource CD in the computer
2. Click Install Medick Explorer
3. Click Next from the Welcome to the Medick Explorer Setup Wizard page
4. Having read and understood the License Agreement click Accept and then
Next
5. Click Next from the Destination page
6. On the Select Start Menu Folder page, click Next
7. On the Select Additional Tasks page, select Create a desktop icon, then
click Next
8. Click Install from the Ready to Install page
9. Click Finish from the Completing Medick Explorer Setup Wizard page.
If the CD-ROM does not respond, use the following procedure:
1. Go to the Start menu and click Run
2. If the letter of your CD-ROM drive is ‘d’, type d:\setup If it is not ‘d’,
substitute the appropriate letter instead
3. Click OK and then follow the instructions as above