Technical data

DVD-/HDD-RECORDER – MD 80857 37
RECORDING TO DVD/HARD DISK
Close programming
` When programming is complete move to the field and confirm by
pressing
ENTER. The recording data is transferred into the table.
` Switch the unit to standby mode.
The automatic recording cannot start if the device is switched on.
If you have forgotten to switch off the device a message appears just
before the recording starts showing the remaining time until the
programmed recording.
Deleting a programmed recording
To remove a programmed recording from the list, open the timer menu
again. Move the cursor over the recording that you wish to delete. Press
CLEAR on your remote control to delete the programme entry from the
list.
A new window requests that you confirm the deletion. To do so move the
cursor to the field and press
ENTER. The entry is deleted from the list.
Stopping a programmed recording
To stop a recording that has already started press STOP during recording.
You can also switch the device into standby mode to end a recording.