User manual

IPCAM User Manual
2.5 For Administrator
When you login as administrator, “For Administrator” is enabled.
Device Info:You can find the information about Device ID,Firmware Version and
Embeded Web UI Version.
Alias Settings: You can Input the new name as you like.
Data&Time Settings: Data&Time Settings page.
Users Settings: Eight accounts are acceptable for this system. Here the eight users can
configure their user names and password as Administrator, Operator or Visitor.
Figure 2.9
z Visitor: In this mode,you can only view.
z Operator:You can control the direction of IP Camera and set some parameter.
z Administrator:You can setup the advanced configurations of the IP Camera.
Set Record Path:Click “Browse” to choose the record path.
Set AlarmRecord Path: Click “Browse” to choose the alarm record path.
the both default path is C:\Documents and Settings\All Users\Documents.
Note: In Windows Vista, there are two points need to notice:
1) Vista's Security level is higher than Windows XP/2000.For "set record path" function,
user should add the Device IP address to the IE's 'Trusted sites' first.
The 'Trusted sites' path: IE browser->Tool->Internet Proper->Security->Trusted
sites->Sites->Add".In Vista,there is a prompt to add Trusted sites when user set
record/Alarmrecord path.
2) In Vista, Cant't Set Windows System Root Directory as the Record/AlarmRecord Path.
These prompts only pop-up in Vista.
UpnP Settings:If you access IP Camera,to be make sure UpnP Status is Succeed.
- 12 -