User manual

IPCAM User Manual
I/O PINS: c Output(+5V) d Output eAlarm input fInput (GND)
Alarm Input Armed
Input Pins: The input pins can be used for 1-way external sensor input. For example, you
may connect a Person Infrared Sensor (PIR) to it for motion detection. When external
sensor triggered, IPCAM can be programmed to send an email with picture or control the
internal relay output.
If you link a external alarm with Pin3 and Pin4,when enable alarm input armed,external
alarm is enabled.
IO Linkage on Alarm
Enable IO linkage on alarm,Pin1 will output +5V when alarm triggered,and output LOW
when alarm release automatically.
Switch on/off
buttons control Pin1 output manually.
Send Mail on Alarm
Sent picture and mail inform to customer’s e-mail after alarmed.(firstly you should finish
the Mail Service Settings.)
Upload Image on Alarm
Enable upload image on alarm and set upload interval(Seconds).
REC on schedule and save to PC
When you enable motion detect and open the camera monitoring page on the PC.If there
is an alarm triggered, REC will start on schedule for several seconds and save to the PC.
Figure 2.19
- 19 -