QUICK REFERENCE The Quick Reference is given to provide basic operation of the unit. Please completely read the user’s guide to take advantage of all the features this unit has to offer.
QUICK REFERENCE (CONTINUED) TO LISTEN TO THE RADIO: 1. Slide the AUTO/BUZZ/ON/OFF switch to the ON position to turn the unit on. 2. Slide the Band switch to the desired band, AM or FM. 3. Tune a station by rotating the TUNING ring. 4. Adjust the volume using the Volume control. 5. Slide the AUTO/BUZZ/ON/OFF switch to the OFF position to turn the unit off.
SAFETY PRECAUTIONS DANGEROUS VOLTAGE: The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
SAFETY PRECAUTIONS (CONTINUED) INFORMATION: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
IMPORTANT SAFETY INSTRUCTIONS Before using the unit, be sure to read all operating instructions carefully. Please note that these are general precautions and may not pertain to your unit. For example, this unit may not have the capability to be connected to an outdoor antenna. 1. READ INSTRUCTIONS All the safety and operating instructions should be read before the product is operated. 2. RETAIN INSTRUCTIONS The safety and operating instructions should be retained for future reference. 3.
IMPORTANT SAFETY INSTRUCTIONS 13. 14. 15. 16. 17. 18. 19. point where they exit from the appliance. LIGHTNING To protect your product from a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power-line surges.
LOCATION OF CONTROLS FRONT 1. Left Speaker 1 2 3 4 5 6 7 8 9 10 11 12 13 REAR 2. Right Speaker 3. AUTO/BUZZ/ ON/OFF Switch 4. SNOOZE Button 5. Band (FM/AM) Switch 6. Minute Hand 7. Hour Hand 8. Second Hand 9. Alarm Hand 10. AM Dial Scale Pointer and Backlight 11. TUNING Ring 14 12. FM Dial Scale Pointer and Backlight 13. Battery Compartment (Bottom of Unit) 14. VOLUME Control 15 15. Clock/Alarm Time Set Knob 16 16. DC IN Jack 4.5V z 17.
POWER SOURCES CLOCK OPERATION To operate the clock, one (1) AA battery must be installed as follows: 1. Remove the battery compartment door on the bottom of the unit by inserting a small screwdriver, paper clip or similar item into the tab while gently pushing, then lifting it out. 2. Insert one (1) AA battery (not included) as shown at the right and according to the polarity diagram. Alkaline batteries are recommended for longer playing time.
POWER SOURCES (CONTINUED) BATTERY PRECAUTIONS Follow these precautions when using batteries in this device: 1. Use only the size and type of batteries specified. 2. Be sure to follow the correct polarity when installing the batteries as indicated next to the battery compartment. Reversed batteries may cause damage to the device. 3. Do not mix different types of batteries together (e.g. Alkaline, Rechargeable and Carbon-zinc) or old batteries with fresh ones. 4.
OPERATION TO LISTEN TO THE RADIO 1 2 2 1 Slide the AUTO/BUZZ/ON/OFF switch 1 to the ON position to turn the unit on. Slide the Band switch 2 to the desired band, AM or FM. Tune a station by rotating the TUNING ring. 3 Antennas FM: Extend the FM antenna wire (located in the battery compartment) for best reception. AM: Turn the unit for better AM reception. 1 2 Adjust the volume using the Volume control ❶. Slide the AUTO/BUZZ/ ON/OFF switch 2 to the OFF position to turn the unit off.
OPERATION (CONTINUED) TO SET OR RESET THE ACTUAL TIME 1 2 Gently pull out the Clock/Alarm Time Set knob on the rear of the unit. Rotate the Clock/Alarm Time Set knob on the rear of the unit until the current time appears on the front clock. Then gently push in the Clock/Alarm 1 Time Set knob to replace the knob. TO SET OR RESET THE ALARM TIME 1 Rotate the Clock/Alarm Time Set knob on the rear of the unit until the Alarm hand points at the desired alarm hour.
OPERATION (CONTINUED) TO SET THE ALARM TO WAKE TO RADIO 1 2 Set the alarm time as previously instructed. Select a radio station as described on page 10 and make sure the Volume control is set as desired. NOTE: Make sure the volume is not at minimum, 1 otherwise, there will be no sound when alarming. Slide the AUTO/BUZZ/ON/OFF switch to the AUTO position. When the actual time matches the selected preset alarm time, the radio will automatically turn on.
OPERATION (CONTINUED) TO SET THE ALARM TO WAKE TO BUZZER 1 2 Set the alarm time as previously instructed. Make sure the Volume control is set as desired. NOTE: Make sure the volume is not at minimum, otherwise, there will be 1 alarming. no sound when Slide the AUTO/BUZZ/ON/OFF switch to the BUZZ position. When the actual time matches the selected preset alarm time, the disney alarm will automatically turn on. 3 To shut the alarm off, slide the AUTO/BUZZ/ON/OFF switch to the OFF position.
OPERATION (CONTINUED) TO SHUT THE ALARM OFF SNOOZE 1 1 To shut the alarm off, slide the AUTO/BUZZ/ON/OFF switch to the OFF position. Slide the AUTO/BUZZ/ON/OFF switch to the AUTO or BUZZ position to reset it for the next day. The alarm can be temporarily turned off manually by pressing the SNOOZE button; the alarm will turn back on automatically 7 minutes later. NOTE: When the SNOOZE button is pressed, the AM/FM Dial Scale Pointer and Backlight will light for 5 seconds.
TROUBLESHOOTING GUIDE Should this unit exhibit a problem, check the following before seeking service: SYMPTOM POSSIBLE CAUSE POSSIBLE SOLUTION AUTO/BUZZ/ON/OFF Set AUTO/BUZZ/ON/OFF RADIO No sound. switch not set to ON. switch to ON. Volume control at Increase the volume. minimum position. Noise or sound AM–Interference from Turn the radio for distorted on AM traffic. better AM reception. or FM. FM–Antenna Wire Extend Antenna Wire. not extended. Batteries dead or weak.
