Operation Manual

65 of 82
7. GPS Factory Reset
Performs a factory reset of the GPS receiver. When using the GPS function after
having performed a factory reset, the GPS receiver must orientate itself again. This
process may take a while.
8. DC AutoSuspend/Wakeup
You can select here when your navigation system should go into Standby mode
automatically after the withdrawal of the external power supply. For example, this
function is useful in the case of vehicles where the cigarette lighter also switches off
when the ignition is switched off.
The AutoSuspend function will be activated several seconds after the
discontinuation of the external power supply and the Standby display will appear
for the time set.
The DC AutoSuspend function will be deactivated again if the power has been
reconnected within the total period (in the case that the engine has been switched
off for a short time, for example). Otherwise, the navigation system will go into the
Standby mode after the expiry of the time set.
Set the required time by clicking on it and confirm your selection with OK.
PLEASE NOTE!
This function is deactivated and can be set individually in the status at
delivery and after a hard reset.
E5x70 Generic EN Gopal 7.5 MSN 4005 1597 Content.indd 65E5x70 Generic EN Gopal 7.5 MSN 4005 1597 Content.indd 65 21.07.2014 10:49:3321.07.2014 10:49:33