Operation Manual

11
EN
Start of operation
Before starting up please make sure that you read the "Safety instructions" section on page 3ff.
Inserting the batteries in the remote control
` Open the battery compartment cover on the back of the remote control.
` Insert two R03 (AAA) 1.5-V batteries in the battery compartment of the remote control. Check the battery
polarity (inscribed on the bottom of the battery compartment).
` Replace the cover.
Note
Remove the batteries if the device will not be used for long periods. The remote control can be
damaged by leaking batteries.
Connect TV aerial
` To connect to the house antenna or cable system, connect a
double-screened cable from the antenna socket to the LCD TV.
Connecting power supply
` Connect the power cable supplied with the device to
the 100-240-V ~ 50/60 Hz connection on the back of
the unit and insert the plug into a 100-240 V ~ 50/60
Hz mains socket near the device.
Switching the LCD TV on and off
` Switch the power button to “ I ” to active the power
supply. The device switches to standby mode and the
display on the front will light up orange.
` To switch on the unit either press the
POWER button
on the remote control or on the right-hand side of
the unit. The display on the front will light up green.
` Press the
POWER button to switch the device over
to standby mode again. The unit continues to consume power in this mode.
` Press the mains switch at the back of the unit to switch it off completely.
Note
If the input signal is interrupted, after some time a countdown will appear on the screen with the
information that the device will be switched off automatically. The unit is in standby mode.