User`s manual

MEDION-Navigator 4.4
Installation and quick-start guide - 15 -
2.2 Installation of the navigation system
2.2.1 Inserting the memory card into the device
Insert the memory
card into the device…
Before using MEDION-Navigator you must insert the memory
card containing the cartographic data into the device.
1. Unpack the memory card carefully. Pay attention not to touch
contacts and not to make them dirty.
2. Hold the memory card
as shown below (label up, cut
corner bottom right). Insert the memory card into the
respective slot
at the left of the device. It should snap in.
Note: The memory card must stay inserted in the device while
you are using the navigation system. If you remove the card
while using the system, it executes a soft reset and prompts you
to insert the memory card.
2.2.2 Installing the navigation software
Install the navigation
software...
1. Take the stylus and push the main switch on the pack of the
device to the ON position.
The brand logo is being displayed for a short time. The
installation procedure starts automatically. A few seconds
later, the initial MEDION screen appears.