Operation Manual

EN-17
EN
Schematic diagram of connection –
may only be performed by specialists:
1. Pink rear view camera cable "CAMERA CONTROL (B+)" to car radio
2. Terminal to connect the pink cable
3. Existing reversing light cable
Test station memory
The standard arrangement for the standard plus and permanent plus cables
in some vehicle models has been switched in the factory (see“Arrangement of
the ISO block” on page 22). This may cause the station memory not to work.
Before you finally install the car radio, try the following to find out if you
stored the stations.
` Reconnect the car battery.
` Turn on the ignition.
` Switch on the radio.
` Go through the automatic station saving process, holding down the AS/PS
button for approx. two seconds (see also“Automatic saving” on page 27).
` Switch off the radio.
` Switch on the ignition again and find out if the stations were been stored
(press the station buttons 1 to 6).
` If the stations were stored, you can install the radio.
` If the stations are no longer in the memory, you should use an adapter
(obtainable from the specialist store) or have the cable adapted in a
specialist garage. If this is the case, refer to Chapter “Explanation for cable
use” on page 20.
82339 DVD-Autoradio DE Content.book Seite 17 Mittwoch, 29. April 2009 8:41 08