Quick Start Guide

85806_QSG_EN_RC1.FH11 Fri Apr 11 13:29:39 2008 Seite 1
Probedruck
C M Y CM MY CY CMY K
5 in 1 HD-Camcorder
MD 85806
English
1.Getting started
You will find a detailed description on the attached CD. With free Adobe Acrobat Reader®
software, you can view and print Adobe PDF files:
http://www.adobe.com/uk/products/acrobat/readstep2.html
Read the detailed instructions, which accompany the equipment.
2.Inserting battery and memory card
Remove the cover to insert the battery and memory card.
· Hold the camcorder with the battery compartment cover facing upwards.
· Remove the cover as depicted on the right.
· Place the battery with the lettering facing downwards in the designated
compartment in the camcorder
.
· Take an SD memory card and slide this into the SD card slot which is underneath
the battery compartment.
Ensure that the contacts on the card are facing downwards.
To close the cover, place the cover on the battery compartment and push the cover
upwards until it clicks into place
.
Main menu
In the main menu there are five sub-menus represented by appropriate symbols. Here
you can select the following settings
:
} To open the menu, press the OK button once.
1 Movie Mode
2 Camera Mode
3 Voice Mode
4 Effect Setting
5 Settings
} To select a menu, press the left/right buttons until the required menu is in the
dark area
.
} To open the required menu, press the OK button.
· To achieve the best picture quality during playback, please remember that:
· Connect your camera using an HDMI cable to your TV set with a digital HDMI
input to view your photos in HD format
.
·
The LC monitor is switched off while the camera is connected to a TV set.
· Y
ou cannot take photographs at a high resolution while the camera is connected
to a television set
.
3.Charging the battery
To charge the battery connect the camcorder to the power supply
Plug the mains adapter into a 230 V ~ 50 Hz socket.
The battery requires approximately six hours to reach full charge for the first time.
Tips for proper use of batteries can be found in the section (safety tips / avoiding
damage to the battery)
.
4.Switching the camcorder on and off
To activate the camcorder, open the display panel as shown below.
Turn the display panel so that you can easily see the 3 LCD display.
To
turn the camcorder off, either simply fold the display panel back to its original
position or press the on/off switch until the LED changes briefly from green (ready to
operate mode) to red and then switches off.
Take care to turn off the device after use to avoid using power unnecessarily.
5.Changing the mode of operation
After start-up the camcorder is in recording mode. You can start taking photos or
recording films immediately.
} Press Record/Play to change from recording mode to playback mode.
} Press Record/Play again to change back from playback mode to recording mode.