User's Manual

7
Reference
Inserting a memory card
CAUTION: Do not apply pressure to the centre of the memory card.
Hold the card (SD or MMC) by the edges and gently insert it into the slot with the label facing the back of the
device.
To remove a card, gently push the top edge of the card inwards to release it, and pull it out of the slot.
Troubleshooting
Note: If you encounter a problem you cannot solve, contact an authorized service center for assistance.
Problems Solutions
Power does not turn on when using battery
power.
The remaining battery power may be too low to run your device. Charge
the battery.
Screen responds slowly. Make sure that your device is not running out of battery power. If the
problem still persists, restart your device.
Screen freezes. Restart your device.
Screen is hard to read. Make sure that the backlight of the display is set to a high-enough
brightness.
Make sure that your device and your computer are both turned on before
trying to establish a connection.
Make sure that the cable is securely plugged into the USB port on your
computer and on the device. Connect the USB cable directly to your
computer—do not run the cable through a USB hub.
Cannot establish a connection with a
computer.
Restart your device before connecting the cable. Always disconnect your
device before you restart your computer.