Instruction manual

14
GB
2 Operation
Off button

If you have activated an alarm but wake up before the set time, you can press
the Off button

to turn off the alarm function. The settings of the alarm func-
tion are kept for the next day. If you do not press the Off button

e.g. if you
wake up before the alarm time and forget to press the Off button

the alarm
function is turned off automatically after about 30 minutes.
You can use Off button

to close any activated function.
Zizz button

If you are taking a short break or what to take a little nap, you can set a short-
time alarm. Press the Zizz button

, on the display

the Zizz icon appears.
Pressing the Zizz button

once sets an alarm to go off in 15 minutes. Every
time you press the button, the time until the alarm is extended by 15 minutes.
The maximum alarm time that can be set for a short-time alarm is 90 minutes.
By pressing the Set button

you confirm your entry and start the countdown
to the alarm at the same time.
In the Zizz function, the setting for sound is preset. If you need to change the
sound, use Set button

to change the setting (see “Setting the time and
alarms manually“ section, page 11-12).
Demo/Snooze/Quick Check button

If you are not using the alarm function, that is, if no alarm was activated by
Alarm button

, the button

can be used for the demo function. Press
the Demo button

. The light gets brighter in 5 second intervals (displayed
levels of brightness 0 – 20). Following that, four sounds of nature are intro-
duced. The entire demo process takes about one minute.
If an alarm has been set but the alarm is not active, you can use the button

to check the settings of the alarm function. Press the Quick Check button

,
and the entered values appear on the display. Press the button

again, to end
the Quick Check function.
If you have activated an alarm time, the countdown for it has already started but
the maximum level of brightness has not been reached, you can use the button

for the snooze function. Press the Snooze button

during 30 minutes and
before setting time, the wake up function (including light and sound) will stop
until the setting time. Then it takes only 1 minute for light and sound to reach
the setting degree. If you press the Snooze button

within 30 minutes after
the setting time, the unit will wake up after 5 minutes, and repeat operation
works within 30 minutes. Every time pressing the Snooze button

stops the
wake up function for further 5 minutes. The maximum to extend the alarm time
is 30 minutes.
If the device is not working correctly, pull the plug from the power point, wait
10 seconds and then plug it in again. Set the time and the other functions again
as described in the “Setting the time and alarms manually“ section, page
11-12.
2.4
Reset function
GA_SAC_West_Final_neu.qxd:Lichtwecker 15.10.2008 12:17 Uhr Seite 14