Installation Sheet

Page 9

WALK-IN TUB MANUAL

operating instructions

INSTALLATION PROCEDURES

WARNING! WHEN INSTALLING JET MASSAGE BATH, THE FOLLOWING BASIC PRECAUTIONS

SHOULD BE FOLLOWED.

DANGER! RISK OF ELECTRIC SHOCK. CONNECT ONLY TO SEPARATE CIRCUIT PROTECTED BY A

GROUND FAULT CIRCUIT INTERRUPTER (GFCI) ON PLUG IN UNITS.

NOTE: INSTALLATION MUST PROVIDE ACCESS FOR SERVICING PUMP/MOTOR (ALL TUBS COME WITH AN ACCESS PANEL

FOR THE PUMP/MOTOR).

GENERAL GUIDE-THROUGH

• Install tub waste/overflow according to instructions (see page 10).

• Standard installation - After framing is a complete (see attached diagrams), set product in place to make certain that the tub can

be properly leveled. (Caution: If a walk-in bathtub is not resting on all leveling feet, water will not drain properly and may cause

the door to leak) (see page 7).

• Verify the product’s level by checking tub’s deck surface and ensure all leveling feet are touching the ground (see page 7).

• Electrical connection is made pre-instruction on specified models.

• After plumbing and electrical connections have been made, the tub should be cleaned of dirt and debris.

• Installation is not complete until the tub has been tested in place.