Product Manual

Vital Signs Monitor User’s Manual
3-3
3.2.3 Starting Monitoring
1. Decide which parameter should be monitored or measured.
2. Install required modules or sensors.
3. Check whether the installation of modules or sensors is correct.
4. Check whether all kinds of settings are correct.
5. Start monitoring on a patient. Detailed information refers to the related chapters.
3.3 Shutting off the Monitor
Please follow the below steps to shut off the monitor:
1. Confirm that the patient monitoring is finished.
2. Disconnect the cables and sensors form the monitor.
3. Confirm that the monitoring data is stored or cleared.
4. Press the power switch and hold it for 1s to turn off the monitor.
Caution
 If the monitor can’t be switched off normally, forced close the monitor by
pressing and holding the power switch for more than 5s. This may cause
some damages to the device.
3.4 Operation Modes
1. Select or in the Icons Area after starting the monitor to enter【Mode
Select】menu.
2. Select【Clinic Mode】or【Monitor Mode】to enter【Continue】menu.
3. If the patient you are going to monitor is the one displayed in【Continue】
menu, please select【Continue】.
4. If the patient is a new one, please select【New Patient】.
5. Input the new patient’s information in 【New Patient】menu.
3.5 Using Menu
Turn the Trim Knob left or right to select【Menu】to open the following main
menu. You can finish most operations and sets through【Menu】. The main menu