Product Manual

6.
A
ttach one end of air tube to the base of the nebulizer.
7.
A
ttach the other end of air tube to the air tube connector located on the
front of the compressor.
8.
A
ttach mouth piece or mask per
y
our choice to the top section of nebulizer.
9. Plug the power cord into an appropriate electrical outlet. Make sure at this
stage, the power switch is at “OFF” status.
10. Press power switch to begin your prescribed treatment.
Important:
The compressor motor has a thermal protector which will shut off the unit
before the unit is overheated. When the thermal protector shuts the unit off,
please:
a. Switch off the unit.
b. Unplu
g
the unit from the electrical outlet.
c. Wait 30 minutes for the motor to cool down before another treatment.
Make sure the air openings are not obstructed.
11. When treatment is finished, shut off the unit and unplu
g
it from the electrical
outlet.
5. CLEANING
It is recommended that the nebulizer, mouthpiece and mask are thoroughly
cleaned with hot water after each use and cleaned with a mild detergent after the
last treatment of the day. If your physician or respiratory therapist specifies a
different cleaning procedure, follow their instructions.
Caution:
Before cleaning, make sure the power cord is disconnected with the main outlet
and the unit.
Rinsing (after each treatment)
1. Disconnect the air tube, nebulizer, mouthpiece and mask.
2. Gentl
y
twist the nebulizer to open it.
3. Rinse the nebulizer, mouthpiece and mask with water.
4. Dr
y
them with clean soft towel or let it air dr
y
.
5. Reassemble the nebulizer when completel
y
dr
y
and put these parts in a dr
y
,
sealed container.
5