Product Manual

5
5.
A
ttach one end of air tube to the base of the nebulizer.
6.
A
ttach the other end of air tube to the air tube connector located on the front
of the compressor.
7.
A
ttach the interface accessory of your choice to the top section of nebulizer.
8. Plu
g
the power cord into an appropriate electrical outlet. Make sure at this
stage, the power switch is at “OFF” status.
9. Press the power switch to “ON” status to begin your prescribed treatment.
Important:
The compressor motor has a thermal protector which will shut off the unit
before the unit is overheated. When the thermal protector shuts the unit off,
please:
a. Switch off the unit.
b. Unplu
g
the unit from the electrical outlet.
c. Wait 30 minutes for the motor to cool down before another treatment.
d. Make sure the air openin
g
s are not obstructed.
10. When treatment is finished, shut off the unit and unplug it from the electrical
outlet.
5. CLEANING
It is recommended that the nebulizer and the mask (or other patient accessory
interface used) are thoroughly cleaned with hot water after each use and cleaned
with a mild detergent after the last treatment of the day. If your physician or
respiratory therapist specifies a different cleaning procedure, follow their
instructions.
CAUTION:
Before cleaning, make sure the power cord is disconnected from the main outlet
and the unit.
Rinsing (after each treatment)
1. Disconnect the air tube from the nebulizer. Disconnect the mask or other
patient accessory interface from the nebulizer.
2. Gentl
y
twist the top part of the nebulizer counter-clockwise to disassemble
the nebulizer.
3. Rinse the nebulizer and mask
(
or other patient interface
)
with water.
4. Let these components air dr
y
,awa
y
from direct sunli
g
ht.
5. Reassemble the nebulizer when completely dry and put these parts in a dry,
sealed container.