Installation Instructions Part 1
Table Of Contents
- Table of Contents
- CHAPTER 1 Description of the Medtronic MiniMed 2007C Implantable Insulin Pump System 11
- CHAPTER 2 Indications and Contraindications 21
- CHAPTER 3 Personal Pump Communicator (PPC) 25
- CHAPTER 4 Pump Implantation 77
- CHAPTER 5 Pump Refill Procedure 97
- CHAPTER 6 Explanting the Pump System 107
- CHAPTER 7 Warnings And Precautions 109
- CHAPTER 8 Adverse Reactions 115
- CHAPTER 9 System Alarms and Messages 117
- CHAPTER 10 Troubleshooting Pump System Under-delivery 131
- CHAPTER 11 MiniMed 2007C Implantable Insulin Pump System 133
- APPENDIX A Label Information 137
- APPENDIX B Implant Worksheet 141
- APPENDIX C Refill Form 143
- APPENDIX D Precautions and General Procedures 145
- APPENDIX E Pump Rinse Procedure 151
- APPENDIX F Side Port Catheter Flush Procedure 163
- APPENDIX G Stroke Volume Measurement 175
- APPENDIX H Pressure Measurement Using The Side Port Catheter 181
- CHAPTER 1 Description of the Medtronic MiniMed 2007C Implantable Insulin Pump System
- CHAPTER 2 Indications and Contraindications
- CHAPTER 3 Personal Pump Communicator (PPC)
- Introduction
- Part 1: PPC/Pump system initialization
- Part 2: Additional PPC programming features
- Main menu
- Program a bolus
- Set a normal bolus with the variable bolus feature turned off
- Set a normal bolus with the variable bolus feature turned on
- Set a square wave bolus
- Set a dual wave bolus
- Review bolus history
- Suspend mode
- Programming a basal rate
- Programming basal delivery pattern
- Setting basal rate profiles in each delivery pattern
- Program a temporary basal rate
- Set a temporary basal rate
- Stop a temporary basal rate
- Personal events
- History
- Main menu
- Setup Pump
- Setup II
- Audio bolus
- Activating the audio bolus feature
- Set an audio bolus from the main menu bolus screen
- Variable bolus
- Refill
- Priming
- Diagnostic rate
- Initialize to factory defaults
- Download software
- Stop Pump
- Supervisor password
- Exit supervisor
- Personal Pump communicator messages
- Clinical history codes
- Clinical history PPC/Pump codes
- Audio bolus
- CHAPTER 4 Pump Implantation
Part 2: Additional PPC programming features
55
2. Press ACT and “ON” or “OFF” begins
flashing.
3. Use the ▲
▲▲
▲ and ▼
▼▼
▼ buttons to select “ON”,
then press ACT again. The “PERSONAL
EVENTS” screen will now appear on the
main menu. Allow the PPC to return to
the Time/Date screen.
4. To set an event: From the Time/Date
screen press SEL until the “EVENT”
screen is displayed then press ACT.
The screen changes to “SET EVENT”
with the word “MEAL” flashing.
Use the ▲
▲▲
▲ and ▼
▼▼
▼ buttons to select the
desired event.
5. Press ACT and the current time will
appear flashing.
Use the ▲
▲▲
▲ and ▼
▼▼
▼ buttons to enter the
time the event occurred.
Press ACT when the proper time is dis-
played. Then allow the screen return to
Time/Date.
NOTE: Only historic or current event times can be
entered.
NOTE: If the Personal Events feature is turned “OFF” in
“SETUP II”, events cannot be entered into the
PPC.
EVENTS
PERSONAL ON/OFF
SET
PERSONAL ON/OFF
EVENTS
SET
EVENT
MEAL
SET TIME
EVENT
MEAL
07:32Am
Dmp9196021-011_c.book Page 55 Thursday, April 4, 2002 8:15 AM