Technical Specs Part 3
Table Of Contents
- CHAPTER 9 System Alarms and Messages
- Pump alarms
- Alarm feedback
- Pump low battery
- Depleted pump battery
- System error
- Pump self test fail
- PPC alarms
- PPC low battery
- PPC depleted battery
- PPC needs servicing
- Low reservoir
- Empty reservoir
- Telemetry communication error
- Initialize alarm
- PPC not initialized
- Battery replacement
- Initialize to factory defaults
- Pump stopped
- Pump suspended
- Auto off
- Hourly maximum exceeded
- Pump alarm table
- Pump alarms
- CHAPTER 10 Troubleshooting Pump System Under-delivery
- CHAPTER 11 Medtronic MiniMed 2007C Implantable Insulin Pump System
Pump alarms
121
NOTE: If while programming the PPC, the screen goes
blank, the PPC beeps six times and then the
“CHECK PUMP STATUS” message appears, the
battery needs to be replaced. (See Chapter 3 for
instructions, Install/Replace the Main Battery).
PPC depleted battery
When the PPC main battery (AA 1.5 volt alkaline) no longer has suffi-
cient power to program the Pump, the following message will appear on
the display:
This message can only be cleared by replacing the PPC battery. For
instructions on changing the battery, (refer to Chapter 3, Personal Pump
Communicator).
PPC Display Type of Alarm
PPC
DEPLETED BATTERY
1
Dmp9196021-011_c.book Page 121 Wednesday, April 3, 2002 5:06 PM