User's Manual
Table Of Contents
- List of figures
- CHAPTER 1 The Medtronic MiniMed 2007D Implantable Insulin Pump System
- CHAPTER 2 Safety features
- CHAPTER 3 Implanting the Medtronic MiniMed 2007D Pump System
- CHAPTER 4 Programming your Pump
- Introduction
- PPC screen icons
- PPC buttons
- Communicating PPC
- Main programming screen
- History
- Pump setup
- Auto off
- Pump Setup II
- CHAPTER 5 Alarms and messages
- CHAPTER 6 Warnings and precautions
- CHAPTER 7 Important Self-Care
- CHAPTER 8 PPC Care and Maintenance
- CHAPTER 9 Technical specifications
Table of contents
37
4. Place the PPC near the Pump and complete
the communication.
5. If “ON” was chosen, the Variable Bolus
option will appear in the Main Menu / Bolus
screen.
Set a maximum bolus
Your doctor will decide if you should use this feature. Setting a maximum
bolus amount will minimize the chance of you over-delivering insulin in case
you make a programming mistake.
1. From the “SETUP II” menu, press SEL until
the “MAX BOLUS” screen is displayed.
2. Press ACT and the screen will change to
“SET MAX BOLUS,” with the dashes
flashing.
3. Use the and buttons to enter a
maximum bolus amount (0.0U to 25.0U),
then press ACT.
4. Place the PPC near the Pump and complete
the communication. The PPC screen will
automatically change to the “MAX BASAL
RATE” screen and then times out to the
Time/Date screen if no further action is
taken.
PPC
COMMUNICATING
MAX BOLUS
_ _ U
MAX BOLUS
_ _U
SET
PPC
COMMUNICATING