User's Manual
Table Of Contents
- © 2008, Medtronic MiniMed. All rights reserved.
- U.S., International, and foreign patent applications are pending.
- Paradigm® is a registered trademark of Medtronic MiniMed.
- MySentry™ is a trademark of Medtronic MiniMed.
- MySentry
- Contents
- Chapter 1: Introduction 1
- Chapter 2: Basics 9
- Chapter 3: Getting started 15
- Chapter 4: Everyday use 23
- Chapter 5: Maintenance 31
- Chapter 6: Specifications 33
- Chapter 7: Frequently asked questions 45
- Chapter 8: End user software license agreement 49
- Introduction 1
- Basics 2
- Getting started 3
- Everyday use 4
- Maintenance 5
- Cleaning the Monitor
- CAUTION:
- . Never place the Monitor directly in water.
- . Never try to clean the inside of the Monitor.
- . Use only a damp cloth and mild liquid soap to clean the Monitor.
- . Never use organic solvents such as lighter fluid, nail polish remover, or paint thinner to clean the Monitor.
- . Never use lubricants of any kind to clean the Monitor.
- CAUTION:
- Cleaning the Monitor
- Specifications 6
- Frequently asked questions 7
- End user software license agreement 8
- Index
MySentry Monitor
16 Getting started
4 Follow the onscreen instructions on your Monitor to set up the pump. A rotating circle indicates that
the linking step is in process, while the Monitor locates the pump.
It takes up to approximately two minutes to complete the linking process.
If the linking process fails, reposition the Monitor and pump and repeat steps 1 through 4.
If the Monitor is still unable to link to the pump, call the 24 Hour Helpline (1-800-646-4633).
Linking the Monitor to the Outpost
Do not move the Monitor or Outpost during this process.
1 Place the Outpost within six feet of the Monitor. Do not plug in the Outpost until directed to do so.
2 From the Main Menu, go to the Link to Outpost screen.
Main menu > Go to Utilities menu > Link to Outpost
3 Follow the onscreen instructions.
It takes approximately two minutes to complete the linking process, and during this time the Outpost
flashes slowly. Once the linking process is complete, the Outpost stays lit. If the linking process fails,
reposition the components and repeat steps 1 through 4.
If the Monitor is unable to link to the Outpost, call the 24 Hour Helpline. The phone number for the 24
Hour HelpLine and the Outpost serial number are listed on the back of the Outpost.