User's Manual
Table Of Contents
- © 2008, Medtronic MiniMed. All rights reserved.
- U.S., International, and foreign patent applications are pending.
- Paradigm® is a registered trademark of Medtronic MiniMed.
- MySentry™ is a trademark of Medtronic MiniMed.
- MySentry
- Contents
- Chapter 1: Introduction 1
- Chapter 2: Basics 9
- Chapter 3: Getting started 15
- Chapter 4: Everyday use 23
- Chapter 5: Maintenance 31
- Chapter 6: Specifications 33
- Chapter 7: Frequently asked questions 45
- Chapter 8: End user software license agreement 49
- Introduction 1
- Basics 2
- Getting started 3
- Everyday use 4
- Maintenance 5
- Cleaning the Monitor
- CAUTION:
- . Never place the Monitor directly in water.
- . Never try to clean the inside of the Monitor.
- . Use only a damp cloth and mild liquid soap to clean the Monitor.
- . Never use organic solvents such as lighter fluid, nail polish remover, or paint thinner to clean the Monitor.
- . Never use lubricants of any kind to clean the Monitor.
- CAUTION:
- Cleaning the Monitor
- Specifications 6
- Frequently asked questions 7
- End user software license agreement 8
- Index
MySentry Monitor
Getting started 19
Adjusting Monitor settings
Follow the procedures in this section to adjust your monitor settings. You can change these settings at
any time.
NOTE: In the procedures below, use the and buttons to scroll through each list of options.
Adjusting user information
The Enter User Info screen enables you to adjust the initials of the person wearing the pump, and the
pump user image. It also displays the pump serial number, which is obtained when the pump is linked
to a Monitor.
To adjust this information, perform the following procedure.
1 From the Main Menu, go to the Enter User Info screen.
Main Menu > Go to Utilities Menu > Edit User Info
2 Scroll to locate each user initial, pressing to confirm your
selection. After you select the second initial, the user image
displays.
3 Scroll to choose your desired image, then press . A
confirmation screen displays.