User's Manual
Table Of Contents
- © 2008, Medtronic MiniMed. All rights reserved.
- U.S., International, and foreign patent applications are pending.
- Paradigm® is a registered trademark of Medtronic MiniMed.
- MySentry™ is a trademark of Medtronic MiniMed.
- MySentry
- Contents
- Chapter 1: Introduction 1
- Chapter 2: Basics 9
- Chapter 3: Getting started 15
- Chapter 4: Everyday use 23
- Chapter 5: Maintenance 31
- Chapter 6: Specifications 33
- Chapter 7: Frequently asked questions 45
- Chapter 8: End user software license agreement 49
- Introduction 1
- Basics 2
- Getting started 3
- Everyday use 4
- Maintenance 5
- Cleaning the Monitor
- CAUTION:
- . Never place the Monitor directly in water.
- . Never try to clean the inside of the Monitor.
- . Use only a damp cloth and mild liquid soap to clean the Monitor.
- . Never use organic solvents such as lighter fluid, nail polish remover, or paint thinner to clean the Monitor.
- . Never use lubricants of any kind to clean the Monitor.
- CAUTION:
- Cleaning the Monitor
- Specifications 6
- Frequently asked questions 7
- End user software license agreement 8
- Index
MySentry Monitor
Specifications 39
Guidance and Manufacturers Declaration – Electromagnetic Immunity
The MySentry system is intended for use in the electromagnetic environment specified below. The customer or the
user of the MySentry system should assure that it is used in such an environment.
Immunity Test IEC 60601 Test Level Compliance Level Electromagnetic
Environment
– Guidance
Electrostatic discharge (ESD) ±6 kV contact ±30 kV air TBD
IEC 61000-4-2 ±8 kV air (<5% relative
humidity)
Electrical fast transient/burst ±2 kV for power supply lines ±2 kV for power
supply lines
TBD
IEC 61000-4-4 ±1 kV for input/output lines ±1 kV for input/
output lines
TBD
Surge ±1 kV line(s) to line(s) ±1 kV line(s) to
line(s)
TBD
IEC 61000-4-5
±2 kV line(s) to earth ±2 kV line(s) to
earth
TBD