How-To Guide
Table Of Contents
- M998590A011DOC_A_FINAL_UserGuide_Part1_5
- Setting up CGM
- Using CGM
- SmartGuard Auto Mode
- About SmartGuard Auto Mode
- Before using SmartGuard Auto Mode
- Setting up SmartGuard Auto Mode
- SmartGuard Auto Mode Readiness
- Home screen with SmartGuard Auto Mode
- Using SmartGuard Auto Mode
- Safe Basal
- Block Mode when in SmartGuard Auto Mode
- Setting Temp Target
- SmartGuard Auto Mode sensor graph
- Enter BG
- SmartGuard Auto Mode Bolus
- Alert Silence
- Exiting SmartGuard Auto Mode
- Returning to SmartGuard Auto Mode
- M998590A011DOC_A_FINAL_UserGuide_Part2
• A new sensor that you just inserted is still initializing.
• A new sensor that just initialized is still calibrating.
• An existing sensor that you have recently reconnected is not ready.
• More than six hours have passed since the initial sensor calibration.
• More than 12 hours have passed since the last sensor calibration.
To view the sensor graph:
1. From the Home screen, press the
button to display the SG graph.
A full-screen view of the 3-hour graph appears.
2. Press
to navigate to the 6-hour, 12-hour, and 24-hour graphs.
3. Press
to view SG readings and event details.
4. To exit the full-screen view, press
or press the button again.
Enter BG
The BG screen lets you manually enter a BG value. When you access the BG screen,
it does not show any previously entered manual or linked meter BG values. If a BG
value is received from a linked meter, that value will immediately display in a
separate BG Meter screen and you will be prompted to confirm the BG value.
When you enter a BG while in Auto Mode, a correction bolus may be suggested.
To manually enter BG readings:
1. Press
and select Enter BG to go to the BG screen.
2. Select Enter BG.
3. Enter a BG value.
4. Select Save.
5. A screen appears prompting you to calibrate your sensor with the BG value if
you want. Select Yes or No.
■
SmartGuard Auto Mode
SmartGuard Auto Mode 231