Product Info
Table Of Contents
- M998590A011DOC_A_FINAL_UserGuide_Part2
- Troubleshooting
- Maintenance
- Product specifications and safety information
- Product specifications
- Alarm and alert escalation
- Altitude range
- Audio frequency
- Backlight
- Basal delivery
- BG Target
- BG meter value
- Bolus delivery
- Bolus Wizard feature default settings
- Bolus Wizard feature specifications
- Carb ratios
- Delivery accuracy
- Easy Bolus feature
- Environmental conditions
- Essential performance
- Filling the infusion set and cannula
- Infusion pressure
- Insulin delivery default settings
- Bolus settings
- Basal settings
- Insulin sensitivity factor
- Low Reservoir reminder
- Max Bolus
- Normal bolus
- Occlusion detection
- Percent temp basal
- Program safety checks
- Pump dimensions
- Pump memory
- Pump weight
- Sensor default settings
- Wireless communication
- FCC notice
- IEC60601-1-2:4th Edition notice
- Guidance and manufacturer's declaration
- Icon glossary
- Product specifications
- 670G Performance Data and Technical Information
• If infusing insulin, do not change the infusion set just before bedtime unless
you can check your BG 1 to 3 hours after insertion.
• Do not use if package has been opened or damaged.
• Ensure sterility by checking that the sterile paper and tamper-proof seal are
not damaged.
• This device is sterile and non-pyrogenic unless the package has been opened
or damaged. Do not use if the package has been opened or damaged. Do not
use the infusion set if the tubing connector needle has been damaged.
• Do not use the infusion set for more than three days. Insulin is not labeled for
more than three days of use when it is used in an infusion set. If insulin is
used in the infusion set for more than three days, it may increase the risk of
set occlusions and cause problems with insulin absorption, which may lead to
severe hyperglycemia and DKA.
• Before insertion, clean the insertion site with isopropyl alcohol.
• Check frequently to make sure the soft cannula remains firmly in place as you
may not feel pain if it pulls out. The soft cannula must always be completely
inserted to receive the full amount of medication.
• Release the tubing with caution as a hard pull of the tubing can result in
damage to the infusion set and introducer needle. Ensure that the infusion set
is properly in place when the tubing is fully released.
• If the infusion site becomes inflamed, replace the set, and use a new site until
the first site has healed. Replace the infusion set if the tape becomes loose, or
if the soft cannula becomes fully or partially dislodged from the skin.
• Failure to remove trapped air from reservoir may result in inaccurate delivery
of medication.
• Never point a loaded insertion device towards the body part where insertion
is not desired.
• Remove the needle guard before inserting the infusion set.
Sensor and serter
For the most current warnings, see the user guide that came with your device.
• Keep the sensor away from children. This product contains small parts and
may pose a choking hazard.
■
Before you begin
Before you begin 19