User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 How to contact Medtronic
- 3 What is the MyCareLink Relay home communicator?
- 4 Setting up the communicator
- 5 Optional: Connecting the communicator to WiFi
- 6 Checking the connection status
- 7 Sending a manual transmission
- 8 Troubleshooting
- 9 Indications for use and contraindications
- 10 Warnings and precautions
- 11 Additional information
- 12 Explanation of symbols
- 13 Specifications
- 14 Federal Communications Commission (FCC) compliance information
- 15 Glossary
Starting up the communicator
To start using the communicator, perform the
following steps:
1. Insert the power supply cord end into the power
port on the back side of the communicator.
2. Plug the power supply wall plug into a power
outlet.
Setup is complete when the green light ring stops
spinning, turns solid, and a 2 part, rising tone plays.
No further action is needed.
Note: If you see something other than a solid green
ring, see Chapter 8, “Troubleshooting”, page 19.
Caution: Use only the power supply that came with
this communicator. Using a different power supply
could damage the communicator and adversely
affect your safety.
Printing instructions: doc #163256
Category: Size-selectable pkg
Size: 4.25 x 6.75 in (108 x 171 mm)
502752-211
9
M971931A001 A Medtronic Confidential Composed: 2018-10-25 10:52:03
PSJ - Size-selectable package manual 14-SEP-2018