User's Manual
Table Of Contents
- Introduction
- About your patient reader
- Indications for use
- Contraindications
- Warnings
- Precautions
- Contents of the patient reader package
- Battery installation
- Indicator lights and the standby button
- Downloading the application
- Bluetooth enabling between the patient reader and the application
- Security key code entry with the patient reader and the application
- Communicating with your implanted device
- Troubleshooting error messages
- Traveling with your patient reader
- Patient reader care
- Storing the patient reader
- How to contact Medtronic
- Patient reader specifications
- Consumer information and Requirements
M957944A001 Rev A Refer to the doc #xxxxxx for
Printing Instructions.
18
M957944A_ch.fm 4/11/14 10:31 am
5.5" x 7.0" (139.7 mm x 177.8 mm)
Medtronic Confidential
Starlight_Pat_R1.5
4. Install the application.
5. Open the application.
Bluetooth enabling between the patient reader and
the application
Your patient reader is paired with the application using a
Bluetooth connection.
To enable the patient reader and the application with Bluetooth,
perform the following steps:
1. Verify that Bluetooth is enabled on your smart phone or tablet.
2. Start the application.
3. Press the Start button in the application.
4. Turn on the patient reader by pressing the standby button.
5. Start the application.
6. Follow the steps in the application to enable the patient reader
with the application.
Security key code entry with the patient reader and
the application
The device label on the bottom of the patient reader contains
product symbols and the security key code. The key code will be
entered into the application to pair your patient reader with the
application.
To pair the patient reader with the application, perform the
following steps:
M957944A001.book Page 18 Friday, April 11, 2014 10:30 AM