User Manual

Problem Causes and Action
The neurostimulator The programmer or detachable antenna is not aligned
lights are off when correctly over the neurostimulator.
you press any key. Move the programmer or antenna and try again.
The programmer was removed from the
neurostimulator too soon.
Hold the programmer over the neurostimulator for at
least 1 second after pressing a key.
Radio signals from appliances, computers,
machinery, etc. are affecting your programmer.
Move to a different room and try again.
Remove the detachable antenna and try again.
The status lights The programmer failed the self-test and/or one of the
do not flash and the programmer’s keys was pressed during battery
beeper does not installation.
beep when a fresh Remove battery, press any key, turn the beeper to
battery is installed. low or high, and insert a second fresh battery, making
sure no keys are pressed during battery installation.
The status lights should flash, and you should hear
one beep. If this does not occur, contact your doctor.
96
9900213EN/197877_001/ccs 1/29/01 2:18 PM Page 96