User Manual

To adjust amplitude, rate, or pulse width:
Remove the battery compartment cover.
Select the
stimulation
setting:
amplitude ( ),
rate ( ), or
pulse width ( ).
Place the
programmer
over your
neurostimulator.
Press the neurostimulator
On key. Listen for the
confirmation beep.
+
l
SN
9V IEC-6LR61
Press the Increase ( ) or
the Decrease ( ) key
to make a change.
You should hear
one beep for
each change.
Repeat steps 2-5 for other
stimulation settings.
Replace the battery cover.
SOUND ACTION
One beep You have pressed the On/Off or
Increase/Decrease key and the
change was received by the
neurostimulator.
Three Indicates one of the following:
rapid • You tried to adjust the
beeps lowest neurostimulator beyond
theor highest settings.
• You tried to increase stimulation
with the neurostimulator
turned off.
5
6
2
3
4
1
If the patient programmer beeps:
9900213EN/197877_001/ccs 1/29/01 2:18 PM Page 4