User Manual

If your doctor has programmed the neurostimulator with the

SoftStart

™

/Stop feature, the magnet will automatically start the

increase or decrease. If the neurostimulator has been programmed

with a dosage of stimulation, the magnet will start the dose.

Note: Allow a few seconds for the SoftStart circuit to raise

the amplitude to the point where you can feel it.

If your doctor has programmed the neurostimulator with the

cycling feature and you use your magnet (or patient programmer)

to turn off the neurostimulator, your therapy will then stop. When

you reapply the magnet to turn on the neurostimulator again, your

therapy always starts at the beginning of the On cycle.

9900213EN/197877_001/ccs 1/29/01 2:18 PM Page 78